Surface (Wall) Mounting (Option S) - Ametek AN-3100D Installation And Configuration Manual

Surface (Wall) Mounting (option S)

Mounting to a wall or other surface. The annunciator is hinged on one side to
allow access to the terminal blocks in the rear of the unit. The hinge may be
moved to the right side of the annunciator by removing the brackets, rotating
them and re –mounting them to the opposites side(s). Refer to table for
available sizes and dimensions. All mounting holes sized for ¼ -20 hardware.
A minimum of 10" of swing clearance is required on the hinge side of the
annunciator.
Hinge side
Refer to the following chart and the figures on the following page for mounting
dimensions.
Dimension
1H
A 3.65
4.93
B
C 0.40
D 1.90
-------
E
-------
F
G -------
H 2.23
AN-3100D ANNUNCIATOR INSTALLATION AND CONFIGURATION MANUAL
ANNUNCIATOR SIZE
2H 3H 4H
7.12 10.59 14.06
8.40 11.87 15.34
1.12 1.12 1.12
4.59 4.59 4.59
------- 8.05 8.05
------- ------- 11.52
------- -------
5.70 9.17 12.64
5H 2W 3W
17.53
18.81
1.12
4.59
8.05
11.52
14.99
16.11
8.74 12.21
8.39 11.86
10.24 13.71
i.
Dimension
4W 5W
15.68 19.15
J
15.33 18.80 K
17.18 20.65 L
27