Starting E-Diagtools From The Utility Partition; Starting E-Diagtools From The Cd-Rom; Running Hp E-Diagtools - HP Linux workstation x1100 Getting Started Manual

Hide thumbs Also See for Linux workstation x1100:

Table of Contents

troubleshooting your workstation

hp Diagtools hardware diagnostics

NOTE

starting e-Diagtools from the utility partition

This method will only work if the diagnostics partition on your hard disk

drive is intact.

1. Restart your workstation and select "diagtools" from the "LILO

menu."

2. In the menu, select the option to run e-Diagtools hardware

diagnostics.

1. Insert the e-Diagtools CD-ROM in the CD-ROM drive.

2. Restart the workstation.

3. Select the option to run the hardware diagnostics.

If you are unable to boot from your CD-ROM drive, restart your

workstation and press

device settings to ensure that your workstation can boot from the

CD-ROM.

Make sure:

•

The workstation model must match the CD-ROM (the CD-ROM is

locked to a speciﬁc workstation model).

•

CD-ROM drive has been conﬁgured to boot before the hard disk

drive.

to enter HP's Setup program. Check the Boot

Chapter 3

Table of Contents