Starting Diagtools From The Hp Image Creation & Recovery Cd-Rom - HP Vectra VL600 User Manual

NOTE
2 If You Have a Problem
HP DiagTools Hardware Diagnostics Utility
This method will only work if you have left the Diagnostics partition on
your hard disk drive intact.
Starting DiagTools from
ROM
To start DiagTools from the CD-ROM:
1 Restart your PC and press F2, when prompted, to enter HP's Setup
program.
2 Ensure that your PC's boot order is set so that it will start on the
CD-ROM, DVD-ROM CD-RW drive (either in the PC's Setup program
or by pressing F8 during startup).
3 Insert the HP Image Creation & Recovery CD-ROM into the CD-
ROM drive.
4 Restart the PC.
5 The PC will start (boot) from the CD-ROM and display a menu.
6 In the menu, select "Run the diagnostics on your PC" and follow the
instructions on-screen to carry out the diagnostic tests.
30
the HP Image Creation & Recovery CD-