SE-1010 PC ECG User Manual
Item
Auto upload
when sampling stops
Auto upload
when making diagnosis
Click on the Barcode Setting tab to open the Barcode Setting window.
Item
Barcode Setting
If the bar code reader cannot be automatically detected, you can make related settings as the
following procedures show:
1. Connect the bar code reader to the PC
2. Click on start, right-click on My Computer, and then select Manage in the pop-up menu to
display the Computer Management screen.
Description
Select this item, the system will automatically upload files to Smart
ECG Net system when sampling finishes.
Select this item, the system will automatically upload files to Smart
ECG Net system when making diagnosis.
Figure 8-5 Barcode Setup Window
Description
Enter the start and end addresses, the male and female codes and the
device port, and then click on the OK button confirm.
NOTE: Only bar code readers recommended by the manufacturer
can be used.
- 53 -
Configuring the System