Data I/O PSV5000 Operator's Manual page 45

Figure 41: [Left] At the Gantry window, the Tool label has been clicked.
3. Open the safety door.
WARNING:
motion of the gantry only. It does not remove electrical power from
the machine or any optional equipment.
Turn the main power OFF for safety unless otherwise directed.
4. Push the head assembly down for access to the probe.
5. IF A RETAINING CLIP IS PRESENT: Pull the Retaining Clip out, away
from the probe grasping it opposite the thin aligning pin.
Fixed Aligning pin
Spring Clip
(shown gold here)
Probe Tip
Figure 42: If a Retaining Clip was used, remove the Spring Clip from the
probe prior to pulling off the tip.
PSV5000 Operator's Manual
■ List of Steps to Start a Job ≡ Identifying the Correct Probes
Shock hazard! Opening the safety doors stops
Pull
Pull
- 41 -