CAUTION
CAUTION
Keysight N4373E Lightwave Component Analyzer Setup Guide
10 Repeat step 3. to step 9. to connect Port A on the optical test set to
Port 1 on the network analyzer.
11 Remove the dust cap from the Optical Output.
12 Remove the dust cap from the optical patch cord.
13 Connect the optical patch cord.
14 Repeat step 11 to step 13 for the optical input.
Always use optical patch cords to connect to your DUT. This protects the
connectors of the optical test set, by minimizing the number of connector
changes.
Make sure to connect only matching connector types to the optical test
set: connecting a straight connector to an angled port, or vice versa, will
damage both interfaces.
Setting Up the Instrument
2
33