Table of Contents
Advertisement
Keysight N4373E Lightwave Component Analyzer Setup Guide
8
Function keys
9
Network analyzer Port 1
10
Network analyzer Port 3
11
Network analyzer Port 2
12
Network analyzer Port 4
Used to control the Lightwave Component
Analyzer.
Press the [Macro/Local] Utility button on the
network analyzer to display the LCA function
keys under Macro 1 group.
•
: Setup an LCA Measurement
•
: Perform a single sweep
measurement with the current
measurement setup
•
: Perform continuous sweep
measurements with the current
measurement setup
•
: Start the optical power meter
•
: Start the LCA server (if not
already running)
This is an S parameter measurement port of the
network analyzer.
Depending on the S parameters of the
measurement this can be either an RF input or
an RF output.
This is an S parameter measurement port of the
network analyzer.
Depending on the S parameters of the
measurement this can be either an RF input or
an RF output.
This is an S parameter measurement port of the
network analyzer.
Depending on the S parameters of the
measurement this can be either an RF input or
an RF output.
This is an S parameter measurement port of the
network analyzer.
Depending on the S parameters of the
measurement this can be either an RF input or
an RF output.
Introduction
1
19
Advertisement
Table of Contents
