Perkins 904J-E36TA Operation And Maintenance Manual page 100

100
Chapitre Entretien
Liquides conseillés
Adding SCA to the Commercial Heavy-
Duty Coolant for Maintenance
Heavy-duty antifreezes of all types require periodic
additions of SCA.
Test the antifreeze periodically for the concentration
of SCA.
Additions of SCA are based on the results of the test.
The size of the cooling system determines the
amount of SCA that is needed.
Use the equation that is in Table 29 to determine the
amount of SCA that is required, if necessary:
Tableau 29
Equation for Adding the SCA to the Commercial Heavy-Duty
Coolant for Maintenance
V × 0.023 = X
V is the total volume of the cooling system.
X is the amount of SCA that is required.
Table 30 is an example for using the equation that is
in Table 29 .
Tableau 30
Example of the Equation for Adding the SCA to the Commer-
cial Heavy-Duty Coolant for Maintenance
Total Volume of the Multiplication
Cooling System (V) Factor
15 L (4 US gal) × 0.023
Cleaning the System of Heavy-Duty
Antifreeze
Clean the cooling system for the following conditions.
• Clean the cooling system after used coolant is
drained or before the cooling system is filled with
new coolant
• Clean the cooling system whenever the coolant is
contaminated or whenever the coolant is foaming
• The cooling system must be free from rust, scale,
and any deposits, before corrosion inhibitors can
be effective
To clean the cooling system of heavy-duty antifreeze,
perform the following steps:
1. Drain the cooling system.
2. Fill the system with suitable distilled or deionized
water.
Most commercial cooling system cleaning agents are
corrosive and their use is not recommended by Per-
kins. If these cleaning agents have to be used to
clean heavy deposits, then they should not be left in
the system any longer then recommended by manu-
facturers. Also the engine temperature should not ex-
ceed 30° C (86° F).
The system must be thoroughly flushed with distilled
or deionized water after use of cleaning agents.
Cleaning agents for industrial cooling system must
not be used. These cleaning agents are very aggres-
sive
components.
3. Dissolve a suitable cleaning agent in water: use
4. Run the engine for approximately 30 minutes,
5. Take a sample of the solution from the system.
Amount of SCA
that is Required
(X)
0.35 L (11.7 oz)
6. Flush the system with distilled or deionized water.
7. Fill the system with new coolant.
REMARQUE
REMARQUE
and cause damage
non-foaming detergent to clean oil contamination
or a cooling system cleaner to clean deposits.
Consult your Perkins dealer for suitable product.
leave the engine to cool down, and drain the
system.
Allow the sample to sit for at least 30 minutes and
check for signs of oil or deposits. If contaminant is
still present repeat step 1 to step 4.
M0092609-04
to cooling system