Aerial Or Cable Installation - Strong SRT32HA3303U User Manual

3.6 Aerial or Cable installation

For Aerial and Cable antenna type following settings are available:
Channel Order
Scan Mode
Select Search once you have completed the settings. Depending on the choice you have done TV set will
display different next steps of installation.
3.6.1 Aerial installation
If you have selected Aerial installation then Auto search process will start directly once you have pressed
OK on Search.
NOTE:
3.6.2 Cable installation
If you have selected Cable installation then you will be guided to Auto Tune sub-menu.
You can select scan type parameter as Quick Scan or Full Scan.
Quick Scan selected by default and advised for quick normal search for provided channels.
You can do scan with all automatically detected settings or additionally specify required settings
according to information from your cable TV provider.
Frequency
Modulation
Symbol
Network ID
NOTE:
NOTE:
Select Start Scan and press OK to continue.
10
Selection of LCN will order channels according to numbering provided by the
TV network operator. Select Service ID if you wish channels to be ordered in
Frequency descending order.
Select DTV to install only Digital TV and Radio channels or select ATV to install
only Analogue TV channels.
If you have an active antenna, please check the user manual of the antenna
for external power supply. The TV cannot supply power used for an active
antenna.
Press BLUE button and enter (using 0 ~ 9) the main frequency used by your
provider in MHz.
Press RED button to define modulation. Available options are: 16 QAM, 32
QAM, 64 QAM, 128 QAM and 256 QAM.
Press GREEN button and enter (using 0 ~ 9) the used Symbol rate in Ks/s from
your provider.
Press YELLOW button and enter (using 0 ~ 9) the used Network ID from your
provider.
Please get and check information for settings for your cable system from
your cable TV provider.
Option Full Scan will scan all frequencies and could take approximately 20
minutes depending on your cable network.