Strong SRT32HA3303U User Manual page 13

LNB Type
22kHz Tone
Toneburst
DiSEqC 1.0
DiSEqC 1.1
Signal Strength and Quality indicators will help you to verify that signal from selected satellite/
transponder is of good quality.
Make settings for each satellite available in your antenna system.
Once you have completed all settings of LNB(s) - press  to continue installation of satellite channels.
Channel Search
On next screen you can select between Auto Tuning and DTV Manual Tuning.
Auto Tuning
Search Type
Satellite
Transponder
Scan Mode
Service Type
Network Search
Search Option
Once you have done all settings - select Search and press OK.
Manual DTV tuning.
This mode allows you to install channels from one transponder of selected satellite.
All search modes are similar to described in above chapter Auto scan.
TV set will search for channels and switch to first channel in the list at the end.
Enjoy watching Digital TV!
Highlight this item and press OK to select between available types, according
to your LNB for selected satellite.
Set Auto for most of cases, especially Universal LNB.
Keep None if there are no Tone Burst switch in your antenna system.
Otherwise, set accordingly to the physical antenna configuration.
Keep None if there are no DiSEqC 1.0 switch in your system. Otherwise, set
port according to the physical antenna configuration.
Keep None if there are no DiSEqC 1.1 switch in your system. Otherwise, set
port according to the physical antenna configuration.
If you select Satellite then the TV will scan all transponders of Selected
Satellites. If you select Transponder then the TV will scan Selected
Transponders of selected satellite.
Highlight this item and press OK to display list of satellites. Mark in the list
satellites which you would like to scan automatically. The item would not be
selectable if Search Type set to Transponder.
Highlight this item and press OK to display list of transponders. Mark in the
list transponders which you would like to scan automatically. The item would
not be selectable if Search Type set to Satellite.
Select between Free to install only free channels, Free+Scramble to install free
and scrambled channels, Scramble to install only scrambled channels.
Select between DTV to install only Digital TV channels, DTV+Radio to install TV
and Radio channels, Radio to install only Radio channels.
Set to Off to scan only transponders preinstalled in TV set. Set to On to scan
transponders which can be discovered through network signaling.
Set to Auto Scan for scanning according to above all settings. Set to Blind
Scan for scanning in case of your selected satellite is not well defined. Blind
scan mode searching transponder by special algorithm which make possible
to discover new transponders. However, this search option is very time
consuming.
9