Table of Contents
Advertisement
If you have connected the TV set to your home router using an Ethernet cable, then the Network setting
screen appears confirming the connection. Press OK to continue the installation.
If you did not connect the TV set with an Ethernet cable, then the Choose Wi-Fi screen will appear. Select
the network from the list or select Skip and press OK.
On the next screen, enter the password for the selected network by using the virtual keyboard. Once
the password entered, select Done on the virtual onscreen keyboard and press OK. The next screen will
confirm the connection to the Internet. You can proceed to the next step of the installation of re-pick
Wi-Fi to select another network.
If you proceed to next step, the Setting completed screen will appear.
3.3 FTI without DTV installation
If you do not want to scan channels and make DTV installation during FTI, select Go to Home screen to
finish installation and press OK to confirm your choice.
If you have selected Go to Home screen the Android Home Menu screen of TV will appear.
Please refer to chapter 4 to read more about how to use Android platform.
3.4 DTV FTI installation
If you want to scan channels and make DTV installation during FTI, select Continue to DTV installation and
press OK to confirm your choice.
On the next screen appears Please select location.
Use t u to select your country from the list.
Once the country is selected, press q to select Next and press OK.
On the appeared screen Select Antenna Type, make your choice of:
Antenna Type
3.5 Satellite installation
If you have selected Satellite antenna type then you have to setup LNB according to your antenna
system.
If you are using single LNB and it is Universal type 9750/10600, then you can skip LNB Setting and go
directly to Search item to start scanning.
Otherwise, select LNB Setting and press OK.
LNB Setting
In this menu setup all settings according to physical parameters of your antenna system.
Satellite
Transponder
LNB Power
Long Cable Compensation Select between ON and OFF. Set to ON if you have high losses in the cable
8
Select Aerial if you wish to install Aerial channels. If you wish to install
channels from connected Cable network, then select Cable. If you have
connected your TV set to a Satellite dish, then select Satellite.
Highlight it and press OK to display list of available satellites, use pq to
select and OK to confirm.
Second item represents transponder of selected satellite. Highlight it and
press OK to display list of available transponders, use pq to select and OK to
confirm.
Use t u to select value corresponded to LNB for selected satellite.
due to its long length. It may help to get signal.
Advertisement
Table of Contents
