Table of Contents
Advertisement
UPS5000-H-(1200 kVA-1600 kVA)
User Manual (100 kVA Power Modules)
Cable
Cable 3
Figure 6-108 Installing signal cables inside the cabinets
Step 8 Install signal cables outside the cabinets.
●
●
●
Issue 03 (2021-04-22)
Position of Wiring Terminal
1
Cabinet
Power cabinet
1
If you need to log in to the WebUI of the UPS monitoring system, connect the
network port on a PC to the FE port on the monitoring interface card.
If the UPS needs to connect to an external network management device,
connect the external network management device to the RS485 port on the
monitoring interface card.
If the UPS needs to connect to the SmartLi, connect the COM port on the
monitoring interface unit in the master SmartLi cabinet to the COM2 port on
the monitoring interface card.
NO TE
The figure uses the cable connection between the UPS and the SmartLi as an example.
Copyright © Huawei Technologies Co., Ltd.
Position of Wiring Terminal
2
Port
Cabinet
One end of
Bypass
the NTC cable
cabinet
is preinstalled.
The other end
is reserved
inside the
cabinet and
needs to be
connected to
the bypass
cabinet.
6 Installation
Port
XS5
127
Advertisement
Table of Contents
