GE SEMIPHOR TRANSPHOR Series Operating Instructions Manual page 48

5 Operation
5.3 Electrotransfer with PWR LARGE SEMIPHOR TRANSPHOR UNIT and PWR SEMIPHOR TRANSPHOR UNIT
Electrotransfer with PWR LARGE
SEMIPHOR TRANSPHOR UNIT and
PWR SEMIPHOR TRANSPHOR
UNIT
Follow the instructions below to start an electrotransfer with PWR LARGE SEMIPHOR
TRANSPHOR UNIT and PWR SEMIPHOR TRANSPHOR UNIT.
Step
1
2
3
48
Action
Turn the instrument on using the POWER button on the front keypad.
Toggle with the DISPLAY MODE button to the current (mA).
Change the value with the UP and DOWN arrows and set the current.
Note:
The transfer cannot be set to run at constant voltage.
Toggle with the DISPLAY MODE button to the time (hour:minutes).
Change the value with the UP and DOWN arrows and set the time.
Note:
While setting the time, there is an extra setting labelled on above the 4:00
upper limit. This will disable the timer, allowing the transfer to run continuously
until manually turned off by the user.
SEMIPHOR TRANSPHOR UNIT series Operating Instructions 29281777 AA