Changing Parameters During The Transfer - GE SEMIPHOR TRANSPHOR Series Operating Instructions Manual

Table of Contents

5 Operation

5.4 Changing parameters during the transfer

5.4

Changing parameters during the transfer

Introduction

This section describes how to change parameters or add buffer during the electrotransfer

using PWR LARGE SEMIPHOR TRANSPHOR UNIT and PWR SEMIPHOR TRANSPHOR UNIT.

Changing the time or current

Both the time and the current can be changed during the electrotransfer run.

Follow the instructions below to change values during a run.

Step

Action

Select mA or time using the DISPLAY MODE button

Change the value with the UP and DOWN buttons

is being changed, the red LED will blink.

Result: About 10 seconds after the values have been changed, the LED will

stop flashing and show the real time run parameters.

SEMIPHOR TRANSPHOR UNIT series Operating Instructions 29281777 AA

. While the value

Table of Contents

Do you have a question about the SEMIPHOR TRANSPHOR Series and is the answer not in the manual?