Safety - ETC Source 4WRD II Installation And User Manual

Safety

The Source 4WRD II fixture is intended for professional use only. Read the
entire manual before using this equipment.
WARNING:
electrician in accordance with all national and local electrical
and construction codes and regulations.
WARNING:
Do not mount the fixture on or near a flammable
•
surface.
Do not use this fixture with a damaged power lead. If
•
the power lead (cord set) is damaged, it must be
replaced.
Mount and support the fixture only by the primary
•
suspension holes in the yoke.
Suspend the fixture from a suitable structure using only
•
hardware rated for the weight of the fixture.
In addition to primary suspension, attach a safety cable
•
to the fixture housing. An appropriate attachment point
(hole) is provided in the protruding tab on the fixture
housing.
Disconnect the unit from power and DMX and allow the
•
fixture to cool before removing or installing accessories,
and before all cleaning and maintenance.
Do not cover the fixture with material that is used for
•
thermal insulation.
Source 4WRD II Installation and User Manual
This fixture must be installed by a qualified
Note the following safety warnings before use:
3