Safety Cable - ETC ColorSource PAR jr Installation Manual

ETC Installation Guide
ColorSource PAR jr
Safety Cable
A safety cable (or other approved safety device) must be attached to the
fixture. The attachment loop is on the rear of the fixture. Leave as little
slack as possible in the safety cable to avoid catching the yoke of the fix-
ture.
Connectors
• Power: Two powerCON
• Data (DMX512/RDM): Two five-pin XLR connectors for data in and
thru
Note:
terminate the last fixture in line with a 120 Ohm resistor. To pur-
chase a terminator, please contact ETC customer service and
request part number SGE1507 (XLR terminator).
Set Up the Fixture
1. Plug the power cord into the powerCON In connector on the rear of
the fixture.
2. Make any power-thru cable connections prior to applying a power
source.
3. Make any DMX connections, and if the fixture is the last in a DMX
line, terminate the fixture. See
4. Plug the power cord into the power source.
Power Up
Press any button to wake the display. The display shows the DMX
address. See
You can press the Mode button to access the Presets/Sequences menu.
See Play Presets and Sequences on page 7
Adjust the Tilt
The fixture can be tilted up
and down and rotated
(panned) as needed.
1. Loosen, but do not
remove the yoke
locking knob.
2. Tilt the fixture to the
desired angle.
3. Tighten the yoke
locking knob.
ColorSource PAR jr
The ColorSource PAR jr is not self terminating. You must
Set the DMX Address on the facing page
®
connectors for power in and thru
Connectors above
.
Yoke
locking
knob
Page 4 of 12
.
.
Accessory
lock
Accessory
slots
ETC