ETC Source 4WRD II Installation And User Manual page 8

Hpl to led retrofit (ce)
Hide thumbs Also See for Source 4WRD II:
Table of Contents

Advertisement

WARNING:
The Source 4WRD II LED is not user serviceable. Field
modification of the Source 4WRD II LED will void your
ETC warranty.
Do not use the fixture below 5°C (41°F).
Minimum storage temperature is 5°C (41°F). When the
fixture has been stored or transported in cold
temperatures, allow it to warm to room temperature
for a minimum of 1 hour before applying power.
Applying power to a cold fixture will cause damage to
the fixture and void the ETC warranty.
Do not use this fixture if a glass lens is deeply scratched
or cracked. Damaged lenses must be replaced.
To prevent wiring damage, or abrasion, do not expose
wiring to edges of sheet metal or other sharp objects.
Use the fixture in dry locations only, where humidity
does not exceed 90 percent (non-condensing). These
fixtures are not intended for outdoor use.
4
Note the following safety warnings before use:
Source 4WRD II Installation and User Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Source 4WRD II and is the answer not in the manual?

Table of Contents