vacuubrand PC 3001 VARIO select Instructions For Use Manual page 58

Cleaning and maintenance
-> Example
Fit the sensor
58
Install the sensor
1. Connect the VACUU·BUS
connector and place the
sensor on the holder.
3. Push the molded hose
onto the connection and
screw on the union nut un-
til it is finger-tight; open-
end wrench SW17.
5. Secure the glass flasks with the joint clamp.
6. Switch on the pumping unit and the vacuum controller.
NOTICE! Re-calibrate the sensor if incorrect values are dis-
played -> see vacuum controller manual.
20901367_EN-US_PC3001 VARIO select Serie_V1.3_100720
2. Insert the screws and
screw them in until they
are finger-tight, hex key
size 3.
4. Turn the pumping unit
right side up and connect
the cables: VACUU·BUS,
power plug.