Terumo CDI 550 Operator's Manual page 47

4-8 chapter 4
6 Repeat steps 1-5 for all the groups you want to set.
Depending on your chosen module configuration, you can select parameters avail-
able from the following group:
Arterial pH
Arterial Temp
Arterial SO
2
Venous PO
2
Venous Hgb
Note: If you are using a venous BPM only (with or without CDI H/S Probe), HCO
BE will refer to venous values.
When you've made all your selections and confirmed them, press the key to move on to
the next screen.
The following figure shows an example of bar graphs that display blood parameter values
during an operation. The graphs make it easy to see the changes in the values over time.
The graphed parameters are the ones you specify on the graphic display screen de-
scribed above. During an operation, you can choose to view patient data in this form.
D 465
calibration
Note: Groups can be rotated in the "operate-graphic" screen by using the
The group number is displayed in the upper left section of the screen. (See the section
"Choosing display modes" in Chapter 7 for more information.)
Arterial PCO
2
Arterial HCO
3
+
K
ḊO
2
Venous pH
Venous Temp
Venous SO
2
D
465
Arterial PO
2
Arterial BE
O
2
Venous PCO
2
Venous HCT
Disabled
- and
3
13:26
9-25-18
C
°
pH-stat
or keys.