User Interface; Status Screen - ETC Releve Spot Installation Manual

ETC Installation Guide
Relevé Spot
Power Receptacle/Connector Specification
Power input and power feed through connections are made to powerCON
and NAC3MCB-1 receptacles on the Power Module. Power In (blue) and Power Thru (gray)
receptacles are keyed differently to prevent intermating.
The luminaire ships with a 1.5 m powerCON power-input cable with a connector of choice. See the
Relevé Spot datasheet for ordering information. Use only compatible power cords with mating
connectors for the specified receptacles.
WARNING:
powerCON should not be connected or disconnected under load or while live!
AVERTISSEMENT :
c'est-à-dire que le powerCON ne doit pas être connecté ou déconnecté lorsqu'il
est sous tension!
See the following wire color code chart:
Wire Color Code
(International
Standard)
Green/Yellow
Blue
Brown

User Interface

The Relevé Spot user interface (UI) consists of a display and button controls for local configuration,
and a USB (type A) port for firmware update. Use the display and button controls to configure the
luminaire for your specific application and installation needs.

Status Screen

When the Relevé Spot is powered up initially, the luminaire runs self tests to check the status of the
features of the luminaire and performs a homing routine. The user interface display shows the
current DMX address, DMX mode, and installed version of firmware. The DMX address will flash
when no DMX is present.
Note:
Relevé Spot firmware is available for download from the ETC website
etcconnect.com/ReleveSpot. USB firmware update instructions are provided in the Relevé
Spot User Operations Manual.
Relevé Spot
The powerCON is a connector without breaking capacity, i.e., the
Le powerCON est un connecteur sans capacité de coupure,
Wire Color Code
(US Standard)
Green
White
Black
ETC recommends running the most current version of firmware in your luminaire.
Connection Terminal
Type
Earth/Ground
Neutral N
Line (Live) L
Page 6 of 8
®
type NAC3MPA-1
ETC