Dmx Start Address; Maintenance - ETC Releve Spot Installation Manual

ETC Installation Guide
Relevé Spot

DMX Start Address

The user interface allows configuration of the DMX Start Address to any value between
001 and 488. By default, the address is set to 001. The DMX Start Address information is stored in
the luminaire even when power is removed.
Note:
enables menu access to set the luminaire DMX Start Address as well as other luminaire
configuration data, even when mains power is removed.
1. With the status screen shown, press the navigate right button > on the user interface. DMX
address "001" is shown by default.
2. Press Enter o. The ones value is selected for edit.
3. Change the value.
Press the navigate left button < to move the selection to the tens or hundreds value.
•
Press the navigate up button Λ or the navigate down button V to change a selected value.
•
4. Press Enter o to set the value and exit DMX Start Address menu.

Maintenance

Regular maintenance of the Relevé Spot luminaire is recommended to ensure optimal performance
for the life of the luminaire.
Note:
your own risk.
WARNING:
power to the luminaire before working inside could result in serious injury or
death.
Disconnect power from the luminaire and follow appropriate Lockout/Tagout
procedures as mandated by NFPA 70E. Any work must comply with OSHA Safe
Working Practices and follow requirements by local code.
AVERTISSEMENT :
l'intérieur du luminaire sans avoir déconnecté le courant peut entrainer des
blessures graves, voire mortelles.
Déconnectez l'alimentation du luminaire et suivez les procédures de
Consignation/Déconsignation appropriées prescrites par la norme NFPA 70E.
Tout travail doit être conforme aux consignes de sécurité du travail de l'OSHA
et respecter les codes locaux.
CAUTION:
performing routine maintenance.
See the Relevé Spot User Operations Manual for maintenance procedures. Relevé Spot manuals are
available for download from the ETC website: etcconnect.com/ReleveSpot.
Relevé Spot
The luminaire features an auxiliary battery in the Main Control Module which
Any service or maintenance that you perform on your Relevé Spot luminaire is at
RISK OF DEATH BY ELECTRIC SHOCK! Failure to disconnect all
RISQUE DE MORT PAR ÉLECTROCUTION! Travailler à
Allow the luminaire to cool completely before servicing or
Page 8 of 8 ETC