Measuring Point Designation / Selection; Parameter Of Measurement (Re-Check) - TESTO Sensor LD pro Instruction Manual

Operation

10.6.1 Measuring point designation / selection


Store Meas. Point

10.6.2 Parameter of measurement (Re-Check)


Store Parameter
At this point, it is again possible to check and correct the parameters „Pressure" and „Distance".
Changing the parameters gives new values for leakage and cost.
Execution of the corrections see description
Testo Sensor LD pro V2.00
All information about the measuring point can
be changed by selecting the corresponding text
field or the stored measuring points can be
loaded from the internal database.
Then a menu opens with the available / saved
entries.
When selecting a saved value, select it
(highlighted in green) and then take over with
„OK".
If a new entry is necessary, the input menu
opens after pressing the „new" button.
Input is accepted via „OK".
This procedure is analogous to enter the
information for company, building and location.
Using the „delete" button, individual entries can
be deleted.
chapter 10.2
Page 22 of 48