A Installing The Expansion Module; Installation Procedure; Step 1: Place Phone And Module On A Table - AudioCodes 400HD Series Administrator's Manual

Administrator's Manual
A Installing the Expansion Module
Before installing the Expansion Module for your phone, make sure the following items are
included in the shipped box:
Expansion Module

Kit containing five screws

Note: Applies to AudioCodes' 450HD and C450HD phones.
A.1

Installation Procedure

Note: Before proceeding with the installation:
• Disconnect the phone from the Power Supply / Power over Ethernet (PoE)
Obtain a Philips screwdriver
•
 To connect the Expansion Module to the 450HD phone:
1. Step 1: Prepare the two units – see
2. Step 2: Remove the phone's side panel – see
3. Step 3: Connect the Expansion Module to the phone – see
4. Step 4: Attach the panel removed from the phone in Step 3, to the Expansion Module –
see below
5. Step 5: Secure the assembly – see
6. Step 6: Install the Expansion Module's base stand and the phone's base stand - see
below
7. Step 7: Mount the assembled unit - see
A.1.1

Step 1: Place Phone and Module on a Table

Place the phone and the Expansion Module on a table alongside one other.
Version 3.4.4
A. Installing the Expansion Module
below
below
below
below
201 400HD IP Phones Series - Teams Compatible
below