Table of Contents
Advertisement
6. Turn the water on.
7. Start the motor and run it until the clippings no
longer come out from under the machine.
8. Shut off the motor.
9. Shut off the water and disconnect the hose from
the machine.
10. Start the motor and run it for a few minutes to
dry the underside of the machine to prevent it
from rusting.
11. Shut off the motor and allow it to cool before
storing the machine in an enclosed area.
Folding the Handle
WARNING: Folding or unfolding the handle
improperly can damage the cables, causing an
unsafe operating condition.
•
Do not damage the cables when folding or
unfolding the handle.
•
If a cable is damaged, contact an Authorised
Service Dealer.
Important: Route the cables to the outside of the
handle hinge as you fold the handle.
1. Remove the electric-start button.
2. Loosen the 2 handle knobs (Figure 21A).
3. Fold the handle by rotating it forward (Figure
21B).
A
B
©2020 - Hayter Limited
Spellbrook, Bishop's Stortford,
Herts, CM23 4BU
Figure 21
Maintenance
Remove the electric-start button and battery pack
from the machine before maintaining or cleaning
the machine.
Use
only
the
replacement parts and accessories.
Inspect and maintain the machine regularly. Have
the machine repaired only by an Authorised Service
Dealer.
Replacing the Blade
Service Interval: Yearly
Important: You will need a torque wrench to install
the blade properly. If you do not have a torque
wrench or are uncomfortable performing this
procedure, contact an Authorised Service Dealer.
If the blade is damaged or cracked, replace it
immediately. If the blade edge is dull or nicked, have
it sharpened and balanced, or replace it.
WARNING: When servicing the blade, be aware
that the blade can still move even though the
power source is off. The blade is sharp; contacting
the blade can result in serious personal injury.
Wear gloves when servicing the blade.
1. Remove the electric-start button and battery
pack from the machine.
2. Use a block of wood to hold the blade steady
(Figure 22).
3. Remove the blade, saving all mounting hardware
(Figure 23).
4. Install the new blade and all mounting hardware
(Figure 23).
17
manufacturer's
recommended
Figure 22
Printed in China
All Rights Reserved
Advertisement
Table of Contents
