Table of Contents
Advertisement
Important: Position the curved ends of the blade to
point toward the mower housing.
5. Use a torque wrench to tighten the blade bolt to
45 N·m.
Important: A bolt torqued to 45 N·m is very tight.
While holding the blade with a block of wood, put
your weight behind the ratchet or wrench and
tighten the bolt securely. This bolt is very diffi cult
to overtighten.
Lubricating the Machine
Service Interval: Yearly or before storage
Apply a few drops of No. 2 lithium grease to the ball
bearings on each of the wheels (Figure 24).
1.
Adjusting the Self-Propel Lever
Whenever you install a new self-propel cable or if
the self-propel drive is out of adjustment, adjust the
self-propel drive.
1. Turn the adjustment nut counterclockwise to
loosen the cable adjustment (Figure 25).
©2020 - Hayter Limited
Spellbrook, Bishop's Stortford,
Herts, CM23 4BU
Figure 23
1
Figure 24
Ball bearings
1.
Handle (left side)
2.
Adjustment nut
3.
Self-propel-drive
cable
2. Adjust the tension on the cable (Figure 25) by
pulling it back or pushing it forward and holding
that position.
Note: Push the cable toward the motor to
increase the traction; pull the cable away from
the motor to decrease the traction.
3. Turn the adjustment nut clockwise to tighten the
cable adjustment.
Note: Tighten the nut fi rmly with a socket or
wrench.
Preparing the Battery Pack for Recycling
Important: Upon removal, cover the terminals of
the battery pack with heavy-duty adhesive tape. Do
not attempt to destroy or disassemble the battery
pack or remove any of its components.
Contact your local council or your authorised Hayter
dealer for more information on how to responsibly
recycle the battery.
18
1
2
4
5
3
Figure 25
4.
Turn the nut clockwise to
tighten the adjustment.
5.
Turn the nut
counterclockwise to
loosen the adjustment.
Printed in China
All Rights Reserved
Advertisement
Table of Contents
