Hayter CODE613A Operator's Manual page 21

Troubleshooting
Problem
It is diffi cult to remove the
battery pack from the tool.
The machine is producing a
beeping sound.
The quality of cut is
decreased or unsatisfactory.
The machine is cutting
unevenly.
The machine is vibrating.
©2020 - Hayter Limited
Spellbrook, Bishop's Stortford,
Herts, CM23 4BU
Possible Cause
1. The battery pack/tool is new or there
is corrosion in the battery terminals
and/or the terminals on the tool.
1. The battery pack is not charged.
2. The machine is in an unsafe
position for operation.
3. The machine is overloaded.
4. There is another electrical
problem with the machine.
1. The blade is dull.
1. The blade is dull.
2. The cutting deck is damaged.
1. The blade is bent or damaged.
1. Clean the terminals on the battery and the
tool. Then apply dielectric grease to the
battery terminals; do not use any other type
of lubricant as it can damage the terminals.
1. Remove the battery pack from
the machine and charge it.
2. Ensure that the machine is not at an
extreme angle while operating.
3. Cut the grass at a higher height of cut or
walk at a slower pace while mowing.
4. Attempt the other troubleshooting
actions, if the alarm still sounds, contact
an Authorised Service Dealer.
1. Have the blade sharpened or replaced.
1. Have the blade sharpened or replaced.
2. Contact an Authorised Service Dealer.
2. Inspect the blade and replace if necessary.
21
Corrective Action
Printed in China
All Rights Reserved