If The Drying Results Are Not Satisfactory - Electrolux EDS854J3WB User Manual

24 www.electrolux.com
Problem
No water goes out from Nozzle,
when "Vapour Refresh" cycle is
selected.
Clothes are slightly damp after
using "Vapour Refresh" cycle.
9.2 If the drying results are not
satisfactory
• The set program was incorrect.
• The filter is clogged.
• There was too much laundry in the
appliance.
• The drum is dirty.
• Room temperature is too low or too
high ( optimal room temperature 19°C
to 24°C )
• You have used wet clothes with
"Vapour Refresh" program.
The "Vapour Refresh" program
reduces wrinkle on dry
laundry only. It is not a drying
program.
Possible solution
The water tap is closed, please open the water
tap.
The inlet hose is squashed or kinked, please
check inlet hose connection.
The filter in the inlet hose is blocked, please
clean the inlet hose filter. Refer to relevant
paragraph in " Care And Cleaning" section.
The Nozzle is clogged, please contact the
Service Centre.
Contact the Service Centre if you are still having
problems.
This is Normal. Vapour Refresh uses moisture to
reduce the wrinkle on fabrics. It is recommended
to hang clothes after using this cycle.
If your laundry feels wet rather than slightly
damp, then the household water pressure is
too high. You may need to reduce pressure by
installing a pressure reducing valve at mains
water connection to the household. This must be
done by qualified plumber.
Note: High water pressure is harmful to all
appliances in your household that are connected
to the water supply ie: washing machine,
dishwasher... etc.