EDS6051 Nozzle Lint Filter The lint filter is located at the front of your dryer at the bottom of the door opening. Rating Plate Never operate your dryer without the lint filter. Do not allow lint to build around your dryer.
(not available for all washing machine models). Worktop Mains Cable Water Inlet Hose Worktop Air Inlet Duct Control Panel Door Safety Switch...
Connect the cold inlet hose for the washer and the Remove cold inlet hose from cold water supply. dryer to the Y-Connector and tighten them. Check rubber seal, replace if worn. Cold water tap To Washing Machine Turn on cold supply for a short time to run some water into a bucket or container to clear any contaminants in the line.
The dryer When a new program is selected while the dryer is already running, the drying process will continue This button allows you to select 2 options. using the settings from the new program. continue unload Iron Aid: This option will help in reducing wrinkles on your clean and dry clothes by using a combination of moisture and warm air function.
Press door safety switch button. To activate this option press and hold the “Option” and “Delay” buttons simultaneously until a long beep is heard. To deactivate press and hold the same buttons To obtain the best drying results with small loads until a short beep is heard.
WARNING: Never stop a tumble dryer before the end of the drying cycle unless all items are quickly removed and spread out so that the heat is dissipated. both...
Care And Cleaning Warning! Clean the filter in the valve with a stiff brush or a towel. You must DISCONNECT the appliance from the electricity supply, before you can carry out any cleaning or maintenance work. External Cleaning Clean the appliance only with soap and warm water.
Due to variations in dryer load fabric texture and thickness it is possible that not all items will be dried evenly. It you experience uneven dryness on Normal Dry program please use either Extra Dry or Timer Program but be mindful of the type of fabric being dried to avoid overdrying certain types of fabric.
TROUBLESHOOTING Important Safety Instructions temperature You have used wet clothes with “Iron Aid” option. The “Iron Aid” program reduces wrinkle on dry laundry only. It is not a drying program. Water pressure too low - please check that the water pressure is between Isolated wet spots on fabrics after “Iron Aid”...