If The Machine Is Not Working - Electrolux EDC 3150 Instruction Book

If the machine is not working

Before calling out an engineer, please check through the details below because some faults can be rectified
easily without the need to call out an engineer. If service is called to resolve a problem listed below or to repair
a fault caused by incorrect installation or mis-use, there is a risk that you will be responsible for the cost.
Fault
G
The dryer will not start.
G
The load is not drying properly,
G
or is taking too long to dry.
The area around the dryer is hot.
G
Never attempt to repair the tumble dryer yourself.
Repairs carried out by unauthorised or inexperienced
persons can cause injury or serious malfunctioning.
This appliance complies with the requirements of the following EU directives:
– 73/23/EEC, dated 19.02.1973 – low-voltage directive.
– 89/336/EEC, dated 03.05.1989 (incl. amendment
92/31/EEC) – directive on electromagnetic compatibility.
Check
G
Is the door closed properly?
G
Is there power to the machine?
G
Has the fuse blown?
G
Have you set the timer knob properly?
G
Is the water tank full?
G
Is the Start button pressed in?
G
Was the time set not long enough?
G
Is the load too large?
G
Cotton
Synthetics
Is the fluff filter clogged?
G
Is the condenser clogged?
G
Was the load not spun enough in the washing
G
machine?
Have you been using the "Synthetics" setting
G
on the timer (lower drying temperature)?
Provided the load is suitable for the higher
temperature, use a "Cotton" setting.
Is the temperature in the room too high?
G
Must not exceed +35° C.
Is the room too small?
G
(Improve the room ventilation, open a door or
window, or choose another site for the dryer.
- 11 -
max. 3,4 kg
max. 1,5 kg