Related Manuals for ADJ REVO 4 IR
Summary of Contents for ADJ REVO 4 IR
- Page 1 REVO 4 IR User Manual WARNING! Due to the magnifying type lens, please keep the lens out of contact with direct sunlight. Direct sunlight can cause heat to build up inside of the unit, which will result in serious damage.
- Page 2 Products, LLC brands and product names are trademarks or registered trademarks of their respective companies. ADJ Products, LLC and all affiliated companies hereby disclaim any and all liabilities for property, equipment, building, and electrical damages, injuries to any persons, and direct or indirect economic...
-
Page 3: General Information
Revo 4 IR General Information Unpacking: Thank you for purchasing the Revo 4 IR by ADJ Products, LLC. Every Revo 4 IR has been thoroughly tested and has been shipped in perfect operating condition. Carefully check the shipping carton for damage that may have occurred during shipping. If the carton appears to be damaged, carefully inspect your fixture for any damage and be sure all equipment necessary to operate the unit has arrived intact. -
Page 4: General Instructions
Revo 4 IR Warranty Registration The Revo 4 IR carries a 2 year (730 days) limited warranty. Please fill out the enclosed warranty card to validate your purchase and warranty. You may also register your product online at www.adj.com. All returned service items whether under warranty or not, must be freight pre-paid and accompany a return authorization (R.A.) number. -
Page 5: Safety Precautions
A. Objects have fallen, or liquid has been spilled into the appliance. B. The appliance has been exposed to rain or water. C. The appliance does not appear to operate normally or exhibits a marked change in performance. ADJ Products, LLC - www.adj.com - Revo 4 IR User Manual Page 5... - Page 6 Data Cable (DMX Cable) Requirements: The Revo 4 IR can be controlled via DMX-512 protocol. The Revo 4 IR can be a four or 256 channel DMX unit. The DMX address is set electronically using the controls on the rear panel of the unit. Your unit and your DMX controller require an approved DMX-512 110 Ohm Data cable for data input and data output (Figure 1).
- Page 7 5-pin XLR connectors in to a 3-pin line a cable adaptor must be used, these adaptors are readily available at most electric stores. The chart below details a proper cable conversion. ADJ Products, LLC - www.adj.com - Revo 4 IR User Manual Page 7...
- Page 8 Revo 4 IR System Menu ADJ Products, LLC - www.adj.com - Revo 4 IR User Manual Page 8...
-
Page 9: System Menu
2. Press the UP or DOWN buttons to adjust the sound sensitivity. 0 being the least sensitive, and 100 being the most sensitive. 3. When you have found your desired setting press ENTER to confirm. ADJ Products, LLC - www.adj.com - Revo 4 IR User Manual Page 9... - Page 10 VER - Use this function to display the Software version of the unit. 1. Press the MENU button until “VER” is displayed, press ENTER. 2. The display will show the software version. ADJ Products, LLC - www.adj.com - Revo 4 IR User Manual Page 10...
-
Page 11: Operation
1. The Revo 4 IR has 4 DMX channel mode and a 256 DMX channel mode. To set the channel mode see the System Menu section. See the DMX Channel Mode sections for detailed descriptions of the DMX traits. -
Page 12: Power Cord Daisy Chain
230V. After the maximum amout of fixtures is connected you will need to use a new power outlet. They must be the same fixtures. DO NOT mix fixtures. ADJ Products, LLC - www.adj.com - Revo 4 IR User Manual Page 12... - Page 13 30 feet away. The Revo 4 IR comes with the Airstream IR remote-transmitter. The transmitter plugs into the headphone jack of your iOS phone or tablet. To control your IR fixture, you must raise the volume to the maximum on your iOS phone or table and aim the transmitter at the front of the fixture and be no more than 15 feet away.
- Page 14 To run the chases using Channel 2, the Channel 1 values must be between 100-239. This also ap- plies to controlling the chase speed using Channel 3 Revo 4 IR Traits & Values - 256 DMX Channel Mode ADJ Products, LLC - www.adj.com - Revo 4 IR User Manual Page 14...
-
Page 15: Fuse Replacement
Unit does not respond to sound; 1. Low frequencies (bass) should cause the unit to react to sound. Tapping on the microphone, quiet or high pitched sounds may not activate the unit. ADJ Products, LLC - www.adj.com - Revo 4 IR User Manual Page 15... -
Page 16: Warranty
No accessories should be shipped with the product. If any accessories are shipped with the product, ADJ Products, LLC shall have no liability whatsoever for loss of or damage to any such accessories, nor for the safe return thereof. -
Page 17: Specifications
A.D.J. Supply Europe B.V. Junostraat 2 6468 EW Kerkrade The Netherlands service@adjgroup.eu / www.adj.eu Tel: +31 45 546 85 00 / Fax: +31 45 546 85 99 ADJ Products, LLC - www.adj.com - Revo 4 IR User Manual Page 17...