Directions For Battery Storage - Kubota SIDEKICK RTV-XG850 Operator's Manual

EVERY 100 HOURS OR 3000 KM
3. Remove the push rivet of the sheet and flip up the
sheet.
(1) Push rivet
(2) Sheet
NOTE :
• To remove the push rivet:
1. Push the pin to unlock.
2. Remove the push rivet.
• To install the push rivet:
3. Push the pin to ready to install.
4. Install the push rivet into the hole.
5. Push the pin to lock.
To remove push rivet
Step.1
To install push rivet
Step.3
(1) Pin
4. Remove the battery cover.
RTV-XG850
Step.2
Step.4 Step.5
(P) "PUSH"
(1) Screw
(2) Battery cover
(1) Battery
5. To slow charge the battery, connect the battery
positive terminal to the charger positive terminal
and the negative to the negative, then recharge in
the standard fashion.
6. A boost charge is only for emergencies. It will
partially charge the battery at a high rate and in a
short time. When using a boost-charged battery, it is
necessary to recharge the battery as early as
possible. Failure to do this will shorten the battery's
service life.
7. When exchanging an old battery for a new one, use
battery of equal specification.

6.2 Directions for battery storage

1. When storing the vehicle for a long period, remove
the battery from vehicle, adjust the electrolyte to the
proper level (refillable type only) and store in a dry
place out of direct sunlight.
2. The battery self-discharges while it is stored.
Recharge it once every 3 months in hot seasons
and once every 6 months in cold seasons.
PERIODIC SERVICE
69