Installing The Front Lift Arms - Toro Reelmaster 3100-D Operator's Manual

Figure 12
1. Roll bar
2. Mounting bracket
3. Vent tube
2. Secure each side of the roll bar to the mounting
brackets with 2 flange head bolts and locknuts
(Figure 12). Torque the fasteners to 81 N∙m (60
ft-lb).
3. Secure the fuel line vent hose to the vent tube
on the roll bar with the hose clamp.
CAUTION
Starting the engine with the fuel line vent
hose disconnected from the vent tube
will cause fuel to flow from the hose,
increasing the risk of fire or explosion.
A fire or explosion from fuel can burn
you and others and can cause property
damage.
Connect the fuel line vent hose to the
vent tube prior to starting the engine.
9
Installing the Front Lift
Arms
Parts needed for this procedure:
2 Lift arms
2 Pivot rod
2 Bolt (5/16 x 7/8 inch)
Procedure
1. Remove the 2 bolts that secure the lift arm pivot
shaft link to the lift arm pivot shafts, and remove
g011160
4. Fuel line vent tube hose
5. Hose clamp
and retain the pivot shaft link and bolts
13).
1. Lift arm pivot shaft link
2. Insert a pivot rod into each lift arm and align the
mounting holes
1. Lift arm
3. Secure the pivot rods to the lift arms with 2 bolts
(5/16 x 7/8 inch).
4. Insert the lift arms onto the lift arm pivot shafts
(Figure 15), and secure each with a lift arm pivot
shaft link and bolts previously removed.
Note:
Torque the bolts to 95 N∙m (70 ft-lb).
17
Figure 13
2. Lift arm pivot shaft
(Figure 14).
Figure 14
2. Pivot rod
(Figure
g011161
g011162