Changing The Fuel Filter Canister; Bleeding Air From The Injectors - Toro Reelmaster 3100-D Operator's Manual

1. Water separator/filter
canister
2. Vent plug
3. Tighten the valve after draining.
Changing the Fuel Filter
Canister
Service Interval: Every 400 hours
1. Clean the area where the filter canister mounts
(Figure 63).
2. Remove the filter canister and clean the
mounting surface.
3. Lubricate the gasket on the filter canister with
clean oil.
4. Install the filter canister by hand until the gasket
contacts the mounting surface; then rotate an
additional 1/2 turn.
Bleeding Air from the
Injectors
Note:
Perform this procedure only when the fuel
system has been purged of air through normal priming
procedures and the engine does not start; refer to
Bleeding the Fuel System (page
1. Loosen the pipe connection to the #1 nozzle and
holder assembly.
Figure 63
3. Drain valve
29).
1. Fuel injectors
g336554
2. Move the throttle to the F
3. Turn the key in the key switch to the S
position and watch the fuel flow around the
connector. Turn the key to the O
when you see a solid flow.
4. Tighten the pipe connector securely.
5. Repeat this procedure on the remaining nozzles.
43
Figure 64
position.
AST
position
FF
g008913
TART