Toyota RAV4 Owner's Manual page 295

294
4-5. Using the driving support systems
Immediately after the switch is pressed,
the dynamic radar cruise control indica-
tor will come on. Afterwards, it switches
to the cruise control indicator.
Switching to constant speed control
mode is only possible when operating
the switch with the cruise control off.
2 Accelerate or decelerate, with
accelerator pedal operation, to
the desired vehicle speed (at or
above approximately 30 km/h
[20 mph]) and press the "-SET"
switch to set the speed.
Cruise control "SET" indicator will come
on.
The vehicle speed at the moment the
switch is released becomes the set
speed.
Adjusting the speed setting: P.291
Canceling and resuming the speed set-
ting: P.293
■
Dynamic radar cruise control with
full-speed range can be set when
● The shift lever is in D.
● The desired set speed can be set
when the vehicle speed is approxi-
mately 30 km/h (20 mph) or more.
(However, when the vehicle speed is
set while driving at below approxi-
mately 30 km/h [20 mph], the set
speed will be set to approximately 30
km/h [20 mph].)
■ Accelerating after setting the vehi-
cle speed
The vehicle can accelerate by operating
the accelerator pedal. After accelerat-
ing, the set speed resumes. However,
during vehicle-to-vehicle distance con-
trol mode, the vehicle speed may
decrease below the set speed in order
to maintain the distance to the preceding
vehicle.
■
When the vehicle stops while fol-
low-up cruising
● Pressing the "+RES" switch while the
vehicle ahead stops will resume fol-
low-up cruising if the vehicle ahead
starts off within approximately 3 sec-
onds after the switch is pressed.
● If the vehicle ahead starts off within 3
seconds after your vehicle stops, fol-
low-up cruising will be resumed.
■ Automatic cancelation of vehicle-
to-vehicle distance control mode
Vehicle-to-vehicle distance control mode
is automatically canceled in the follow-
ing situations.
●
VSC is activated.
● TRC is activated for a period of time.
● When the VSC or TRC system is
turned off.
●
The sensor cannot detect correctly
because it is covered in some way.
● Pre-collision braking is activated.
●
The parking brake is operated.
● The vehicle is stopped by system con-
trol on a steep incline.
● The following are detected when the
vehicle has been stopped by system
control:
• The driver is not wearing a seat belt.