Toyota RAV4 Owner's Manual page 169

168
3-2. Opening, closing and locking the doors
NOTICE
● Do not subject the kick sensor or its
surrounding area to a strong
impact.
If the kick sensor or its surrounding
area has been subjected to a strong
impact, the kick sensor may not
operate properly. If the kick sensor
does not operate in the following
situations, have the vehicle
inspected by your Toyota dealer.
• The kick sensor or its surrounding
area has been subjected to a strong
impact.
• The lower center part of the rear
bumper is scratched or damaged.
●
Do not disassemble the rear
bumper.
● Do not attach stickers to the rear
bumper.
● Do not paint the rear bumper.
●
If a bicycle carrier or similar heavy
object is attached to the power back
door, disable the kick sensor.
(P.114)
Changing settings of the
power back door system
(vehicles with power back
door)
The settings of the power back door
system can be changed by display-
ing the "Vehicle Settings" - "PBD"
screen from the
multi-information display. (P.114)
The changed power back door settings
are not reset by turning the engine
switch to OFF. In order to restore the
original settings, they need to be
changed back on the
multi-information display.
Adjusting the open position
of the back door (vehicles
with power back door)
The open position of the power
back door can be adjusted.
1
2
When the settings are completed, the
buzzer sounds 4 times.
When opening the back door the next
time, the back door will stop at that
position.
■ Canceling the adjusted open posi-
tion of the back door
Press and hold the power back door
switch on the back door for approxi-
mately 7 seconds.
After the buzzer sounds 4 times, it
screen of the
sounds twice more. When the power
back door does the opening operation
the next time, the door will open to the
initial settings position.
screen of the
Stop the back door in the desir-
able position. (P.159)
Press and hold the power back
door switch on the back door for
approximately 2 seconds.