Toyota RAV4 Owner's Manual page 162

Using the back door handles
■
Lower the back door using the back
door handle A .
The back door closing assist (P.163)
will be activated, and the power back
door will fully close automatically.
Using the kick sensor (vehi-
■
cles with Hands Free Power
Back Door)
The Hands Free Power Back Door
enables automatic opening and
closing of the power back door by
putting your foot near the lower
center part of the rear bumper and
moving it away from the rear
bumper. When operating the Hands
Free Power Back Door, make sure
that the engine switch is in OFF, the
kick sensor operation is enabled
(P.114) and you are carrying an
electronic key.
1 While carrying an electronic key,
stand within the smart entry &
start system operation range,
approximately 30 to 50 cm (11.8
3-2. Opening, closing and locking the doors
to 19.7 in.) from the rear
bumper.
A Kick sensor
B
Hands Free Power Back Door
operation detection area
C
Smart entry & start system oper-
ation detection area (P.170)
2 Perform a kick operation by
moving your foot to within
approximately 10 cm (3.9 in.) of
the rear bumper and then pulling
it back.
Perform the entire kick operation within
1 second.
The back door will not start operating
while a foot is detected under the rear
bumper.
Operate the Hands Free Power Back
Door without contacting the rear
bumper with your foot.
If another electronic key is in the cabin
or luggage compartment, it may take
slightly longer than normal for the oper-
161
3