Warming Up The Machine; Optional Accessory - Optimum OPTImill BF 20V Operating Manual


Lubricate the drilling-milling machine according to the lubricating plan.

"Inspection and maintenance" on page 44

Check if all spindles are running smoothly. The spindle nuts are re-adjustable.

Disassemble the V-ledges of the cross table and clean the ledges from the anti-corrosive

agent. "V-ledges" on page 44
3.4.3

Warming up the machine

ATTENTION!
If the drilling-milling machine and in particular the milling spindle is immediately
operated at maximum load when it is cold it may result in damages.
If the machine is cold such as e.g. directly after having transported the machine it should be
warmed up at a spindle speed of only 500 1/min for the first 30 minutes.
3.5

Optional accessory

Designation
machine base
machine base
Collet chucks kit 5-pcs MT2 / M10
directly clamping
Collet chuck holder MT2 / M10 (ER25)
Set of collet chucks, 1-16mm 15 pieces (ER25)
Collet chuck holder MT2 / M10 (ER32)
Collet chucks kit 3-20mm 18-pcs (ER32)
Quick-action drill chuck (0-13mm) B16
Morse taper taper mandrel MT2 / M10 / B16
Mill cutter holding cone MT2 / M10
id=16mm
Machine vice FMSN 100
Three-axis vice DAS 75
slewable, turnable, tiltable
Two-axis vice ZAS 50
slewable, turnable
Chucking tool kit SPW 10
Milling cutter kit 12-pcs (4-5-6-10-12), each two-
and four-edged, TIN-coated
Add-on adapter to the machine bed
lathe TU2506 / TU2807
Adapter for high speed motor
(without high speed motor)
round cell 1,55V 145mAh (SR44)
11.6 x 5.4mm
Version 4.0.2 dated 2019-4-3
Item No
335 3002
335 3003
335 1980
335 2044
344 1109
335 2045
344 1122
305 0623
305 0670
335 2102
335 4110
335 4175
335 4170
335 2016
335 2113
335 6572
335 6571
338 5480
Translation of the original instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
BF20V | BF20L | BF20LD
®
GB
Page 25