Warming Up The Machine - Optimum OPTIMILL MH 28V Operating Instructions Manual


Do not use any solvents, thinners or other cleaning agents which could corrode the var-
nish on the drilling-milling machine. Follow the specifications and indications of the
manufacturer of the cleaning agent.

Lubricate all bright machine parts with non-corrosive lubricating oil.

Grease the drilling-milling machine using the lubrication chart.

"Inspection and maintenance" on page 35

Check the smooth running of all spindles. The spindle nuts can be readjusted.

Disassembly the taper gibs of the cross table and clean the gibs from the anti-corrosive

agent. "Taper gibs" on page 36

3.5.3 Warming up the machine

ATTENTION!
If the drilling-milling machine and in particular the milling spindle is immediately
operated at maximum load when it is cold it may result in damages.
If the machine is cold such as e.g. directly after having transported the machine it should be
warmed up at a spindle speed of only 500 1/min for the first 30 minutes.
Unpacking and connecting
Version 1.0.1 dated 30 / 08 / 2012 Original operating instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
GB
MH28V
Page 23