Table of Contents
Advertisement
3.9
Cleaning the machine
ATTENTION!
Do not use compressed air to clean the machine.
Your new milling machine must be completely cleaned after unpacking to ensure that the
moving parts and sliding surfaces cannot be damaged when the machine is operated. Prior to
delivery, all blank parts and sliding surfaces in each unit are appropriately lubricated to protect
against rust in the period before commissioning. Remove all wrappings and clean all surfaces
with a degreaser to soften and remove protective greases and coatings.
Wipe all surfaces with a clean cotton cloth and lubricate the milling machine in accordance with
the maintenance section
power and putting the machine into service.
3.9.1
Lubrication and oil levels
During the initial lubrication and greasing of your new milling machine, the oil levels are chec-
ked and the machine lubricated after cleaning. Only when this has been done can commissio-
ning of the machine proceed.
Inspection and maintenance on page 56
3.10
Function testing and mounting of accessories
INFORMATION
The movement of the axes with the hand cranks on the table is only possible when the
machine is switched on.
Mount hand lever, spindle sleeve feed, from the standard accessories on the milling head.
Loosen mechanical limit stops of the travelling axles.
Loosen the clamping level and check the smooth running and mobility of travelling axles
and components.
Perform safety check.
3.11
Warming up the machine
ATTENTION!
If the milling machine and in particular the milling spindle is immediately operated at
maximum load when it is cold it may result in damages.
If the machine is cold, e.g. directly after having transported the machine, it should be warmed
up at a spindle speed of only 500 1/min for the first 30 minutes.
3.12
Electrical connection
CAUTION!
Lay the connection cable to the electrical cabinet and the cable of the coded connector
from the machine to the electrical cabinet in such a way as to prevent a trip hazard.
WARNING!
The three-phase electrical connection may only be performed by an electrician or under
the guidance and supervision of an electrician.
Connect both coded connectors to the electrical cabinet.
We recommend using crossing plates, tread plates with black-yellow markings to cover
the connection cable from the machine to the electrical cabinet.
EN
MZ2S
30
Inspection and maintenance on page 56 before switching on the
Safety check on page 15
Translation of original instructions
Version 1.0.4 - 2020-09-08
Advertisement
Table of Contents
