Optimum OPTImill BF 20V Operating Manual page 45

Interval Where?
As required
As required
Version 4.0.2 dated 2019-4-3
What? How?
Readjusting
Z axis

Proceed as described under "Readjusting X and Y axis".
Replacing the
halogen lamp

Tilt the mill head a little to the right. This way you can
easily remove the lamp cover in order to allow replacing
of the halogen lamp.

Plug a small screw driver into the recess between the
lamp holder and the lamp cover.

By slightly turning the screw driver you can remove the
lamp cover.

Pull the halogen pin base lamp with a cloth and replace
the halogen lamp.
Type:
Halogen pin base lamp, Osram 12V - 10W, base G4
Translation of the original instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
Take-up screw
taper gib Z axis
Img.6-2: Milling head
Lamp holder
Halogen pin base lamp
Lamp cover
Img.6-3: Replacing the halogen lamp
BF20V | BF20L | BF20LD
®
GB
Page 45