Assembly And Installation; Personnel Qualification And Training; Safety Instructions; Electrical Connection - GEA RedGenium Operating Instruction

6

Assembly and installation

6.1

Personnel qualification and training

Personnel working on and with the product must have the respective qualifica-
tion. The area of responsibility, competence and the monitoring of the personnel
must be regulated precisely by the operator. If personnel do not have the neces-
sary knowledge, this must be trained or instructed. If required, this may be carried
out by the manufacturer/supplier on behalf of the operator of the product. More-
over, the operator must ensure that the content of the operating manual has been
fully understood by the personnel.
6.2

Safety Instructions

6.2.1

Electrical connection

Before starting work, make sure that all parts to be connected are de-energised,
e.g. by removing the main fuse in all phases or installing a jumper wire.
The insulation resistance of the electrical tools and fixtures and wiring is to be
checked. The connection may only be undertaken if this value lies in the permis-
sible range.
All electrical connections must be established and all electrical consumers/
sensors must be connected according to the circuit diagram.
6.3

Requirements and information on installation

All foundation calculations, the selection of materials and the soil analysis are the
responsibility of the project engineer or the owner.
Prior to installation, a plan must be created for proper and professional installa-
tion. Electrical connections and connections for operating media must be made.
In addition to the installation surface of the product, it must be ensured that suffi-
cient space is available during maintenance work on the pipes as well as for
operation.
Install the product on a level surface. The difference from the horizontal must not
be more than 0.3 %. Provide enough space for maintenance work.
Under normal conditions, the product stands solidly on the installation surface
due to its dead weight. It is advisable to provide ribbed rubber plates in between
the installation surface and base or product base frame.
L_151511_2
19.12.2019
Danger
Contact with live components is prohibited.
► Produce the earth connection according to the designation in the general
assembly drawing. See chapter "Designation of the earth connection".
Caution!
During installation make sure that leaking operating materials do not reach
the soil, groundwater or surface water.
► Follow the legal regulations applicable at the site of installation (e.g. for
Germany, Water Management Act, WHG).
Assembly and installation
Personnel qualification and training
65