Deleting Transmitters; Setting Up The Fan As A Signal Amplifier (Repeater) - Maico ECA 100 ipro RC Mounting And Operating Instructions

EN
3. Press and hold the teach-in button [10] at
the fan (>1 second), until the LED on the
slave fan lights up briefly once.
> The teach-in telegram is sent. If
teaching-in is completed successfully,
the button LED lights up once for
approx. 1.5 seconds. If transfer was
faulty, the button LED flashes briefly 3
times. If the teach-in process fails, the
LED on the slave fan flashes briefly
three times. The process has to be
repeated.

9.6 Deleting transmitters

Deleting an individual transmitter
If there is a transmitter that is faulty or
i
that can no longer be identified, it is
possible that all transmitters must be
deleted. System components than
have to be taught-in again. This is
recommended if a transmitter was lost
or is faulty.
1. In order to delete the required transmitter,
the transmitter teach-in process (RLS RC,
radio switch or window contact) has to be
repeated ( Chapter 9.5).
Deleting all transmitters
1. Activate teach-in mode at the fan.
> The LED flashes, teach-in mode is
activated.
2. Press the teach-in button [10] briefly
twice.
> LED flashes briefly twice and then goes
out.
3. Press and hold the teach-in button [10] on
the fan (>1 second), until the LED on the
fan lights up briefly once.
> All transmitters that have been set up,
are now deleted. The fan is again in its
initial state.
28
9.7 Setting up the fan as a signal
amplifier (Repeater)
The radio electronics in the fan can also be
used as a signal amplifier. In this case, the
fan that is set up this way works additionally
as a signal amplifier. EnOcean telegrams are
received and forwarded in parallel to the
running application.
This can be necessary for example, with
applications in single-family houses that are
completely automated with EnOcean products.
Settings values
● Off
● Level 1 = Original telegrams are amplified
● Level 2 = Original telegrams and telegrams
that have already been amplified are
amplified
Setting up the fan as a signal amplifier
1. Activate teach-in mode at the receiver
(fan).
> The LED flashes, the teach-in mode is
activated.
2. Press the teach-in button [10] briefly three
times.
> The LED lights up briefly and then
flashes briefly three times.
3. Press the teach-in button [10] x times
for repeater mode:
Repeater off
Repeater Level 1 twice LED flashes twice
Repeater level 2 three times LED flashes
three times
4. Press and hold the teach-in button [10] on
the fan (>5 seconds), until the LED on the
fan lights up briefly once for approx. 1
second.
> The setting is saved.
once LED flashes once