Master-Slave Assignment; Switching A Receiver To Teach-In Mode; Setting Up Transmitters - Maico ECA 100 ipro RC Mounting And Operating Instructions

9.3 Master-slave assignment

A fan automatically becomes a
i
master fan if the master unit is set to
receive mode and a teach-in telegram
is received from a slave unit.
9.4 Switching a receiver to teach-in
mode
1. Press and hold the teach-in button [10] at
the receiver (fan) for at least 2 seconds.
> The button LED flashes, the teach-in
mode is activated.
2. Now, a teach-in telegram must be
received within 60 seconds or the teach-in
mode is terminated.

9.5 Setting up transmitters

When a teach-in telegram is correctly
i
received, the receiver's button LED
lights up for 1 second. The transmitter
is now set up.
Teaching-in radio switches
In the case of double-rocker switches
(DS RC), both rockers have to be set up
separately (2 channels).
1. Activate teach-in mode at the receiver
(fan).
> LED flashes. Teach-in mode is activated.
2. Press the radio switch's right-hand rocker
3 times within 2 seconds.
> The teach-in telegram is sent.
If teaching-in is completed successfully,
the LED lights up for approx. 1 second.
If transfer was faulty, the button LED
flashes briefly 3 times.
3. Re-activate teach-in mode at the receiver
(fan).
4. Press the radio switch's left-hand rocker
3 times within 2 seconds.
> The teach-in telegram is sent.
If teaching-in is completed successfully,
the LED lights up for approx. 1 second.
If transfer was faulty, the button LED
flashes briefly 3 times.
5. Re-activate teach-in mode at the receiver
(fan).
6. Press the right-hand rocker 3 times within
2 seconds
> The teach-in telegram is sent.
Teaching-in radio window contacts
1. Activate teach-in mode at the receiver
(fan).
> The LED flashes, the teach-in mode is
activated.
2. Press the teach-in button at the radio
window contact.
> The teach-in telegram is sent.
If teaching-in is completed successfully,
the LED lights up for approx. 1 second.
Teaching-in an RLS RC room air control
The teach-in button is on the rear of the
controller.
1. Activate teach-in mode at the receiver
(fan).
> The LED flashes at the fan, the teach-in
mode is activated.
2. Press the RLS RC teach-in button 3 times
within 2 seconds.
> The teach-in telegram is sent.
If teaching-in is completed successfully,
the radio icon in the display flashes
briefly 3 times.
The radio icon is then permanently
visible in the display.
Teaching-in a slave fan
1. Activate teach-in mode at the master
receiver and at a fan that is not yet set up
(planned slave).
> The LED flashes, the teach-in mode is
activated.
2. Switch the slave to send mode. To do this,
press the teach-in button [10] at the slave
fan briefly once.
> The LED at the slave lights up briefly
and then flashes briefly once. The slave
fan is now in send-learn mode.
EN
27