Additional Required Equipment; Mounting; Remove Av-30 From Instrument Panel (Optional); Backshell Connector Removal - uAvionix AV-30 Service Bulletin

8.2 Additional Required Equipment

Additional Required Equipment
AV-Link is designed to interface with an existing Link is designed to interface with an existing AV-30-E display. To take
advantage of the AV-Link the following equip
AV-30-E 3" Display

8.3 Mounting

AV-Link is mounted in series between the AV Link is mounted in series between the AV-30 and the AV-30 Backshell
Connector.

8.3.1 Remove AV-30 From Instrument Panel (Optional)

It may be necessary, because of space limitations, to remove the AV-30 It may be necessary, because of space limitations, to remove the AV It may be necessary, because of space limitations, to remove the AV
unit in order to perform AV der to perform AV-Link installation. Using a Phillips screwdriver,
remove the four [4] screws that attach the AV remove the four [4] screws that attach the AV-30 to the aircraft instrument
panel. Pull unit down to a workable position. Note that it may also be panel. Pull unit down to a workable position. Note that it may also be panel. Pull unit down to a workable position. Note that it may also be
necessary to disconnect the Pitot and Stat necessary to disconnect the Pitot and Static lines to bring into reach.
Ensure that the lines are properly labeled before disconnecting. Ensure that the lines are properly labeled before disconnecting. Ensure that the lines are properly labeled before disconnecting.
8.3.2 AV-30 Backshell Connector Removal

30 Backshell Connector Removal

Using a flat screwdriver, loosen the two [2] screws that hold the Backshell a flat screwdriver, loosen the two [2] screws that hold the Backshell a flat screwdriver, loosen the two [2] screws that hold the Backshell
Connector to the DB-15 connector on the back of the
Backshell Connector is free to detach from the AV Backshell Connector is free to detach from the AV-30. If present
bonding/ground strap attached to the Backshell Connector.

8.3.3 AV-Link Attachment

Link Attachment
Do not attempt to remove the two [2] captive Jack Screws from the AV Do not attempt to remove the two [2] captive Jack Screws from the AV-Link Do not attempt to remove the two [2] captive Jack Screws from the AV
Housing. Attach the AV-Link to the back of the AV
into the DB-15 connector on the back of the AV 15 connector on the back of the AV-30. Do not push against
the Jack Screws as they will stop against the screw bosses on the AV the Jack Screws as they will stop against the screw bosses on the AV-30 the Jack Screws as they will stop against the screw bosses on the AV
AV-30-E Service Bulletin Software Upgrade 1.1.0 E Service Bulletin Software Upgrade 1.1.0
UAV-1005261-001 Rev A
Link the following equipment is required.
30 From Instrument Panel (Optional)
Link installation. Using a Phillips screwdriver,
15 connector on the back of the AV-30 until the
attached to the Backshell Connector.
Link to the back of the AV-30 by inserting the unit
1 Rev A
display. To take
30 to the aircraft instrument
ic lines to bring into reach.
30 until the
present, leave the
by inserting the unit
30. Do not push against
30 Backshell
15