Segway Snarler AT6 S User Manual page 152

2. Measure the distance from the floor to the center of
the headlights and make a mark on the wall at the
same height.
3. Start the engine. Switch headlights to high beam.
4. Watch the headlight aim on the wall. The most
intense part of the headlight beam should be 5cm
below the mark on the wall. Measure the headlight
aim with the weight of the driver on the front seat.
Adjusting the headlight beam up and down
To raise the headlight beam, turn the headlight adjusting
screw in direction (L). To lower the headlight beam, turn the
headlight adjusting screw in direction (R).
Vertical adjusting screw
1
MAINTENANCE
153