Netware 4.0 Server Drivers - 3Com EtherLink III User Manual

C
4 -2
hapter
2 Select the appropriate driver for your network operating
system from the menu choices.
The menu program copies the selected driver to a specified
disk drive.
3 Refer to your network operating system manuals for
instructions for using the driver with your network
operating system.
few All network adapters in the EtherLink III Parallel Tasking
adapter family (except for the EtherLink III PCMCIA adapters)
use the same drivers. These drivers are backward-compatible
with the previous generation o f EtherLink III adapters.

NetWare 4.0 Server Drivers

The EtherDisk diskette contains a NetWare 4.0 server driver
and five NetWare Loadable Modules (NLMs) that enable the
NetWare 4.0 driver to be used with NetWare 3.11 software.
To load the 4.0 server driver while running NetWare 3.11,
copy all files from the\NETWARE\311SRV subdirectory on the
EtherDisk diskette to the server hard disk.To start the server
driver, enter the following commands:
load C:LSLENH.NLM [Enter]
load C :3C5X9.LAN [Enter]
If this order is not followed, the system will not operate
correctly. When this has been done, bind the protocol to the
driver as usual.
few When running the 3C5X9.LAN driver with NetWare 3.17, you
must update the MONITOR.NLM file that accompanied
NetWare 3.7 7 with the MONITOR.NLM file on the EtherDisk
diskette in the directory \NETWARE\317 SRV.
If you are running NetWare 3.12 or 4.x, use only the
3C5X9.LAN driver from the EtherDisk diskette. Use the
appropriate NLM files from the Novell server installation.
4: I N
nstalling the
D
etwork rivers