Reconfiguring The Adapter For An Isa Computer - 3Com EtherLink III User Manual

7 Exit the program and remove the EtherDisk diskette.
8 Insert the EISA configuration diskette provided with your
computer.
9 Turn off the computer. Wait 10 seconds and then turn it
on again.
10 Follow the instructions that accompanied your EISA
computer to run the EISA configuration program.
When the program asks for .CFG files to copy, insert the
EtherDisk diskette, press [Enter], and use the appropriate file:
■ ITCM5094.CFG for the 3C509B-COMBO adapter
■ ITCM5091 .CFG for the 3C509B coax adapter
■ !TCM5090.CFG for the 3C509B-TP adapter
.
few The sequence o f configuration steps required for some EISA
3^ computers may vary from the steps above. Consult the
configuration program manual provided by the
manufacturer o f your computer for more details.

Reconfiguring the Adapter for an ISA Computer

few Use this procedure only for reconfiguring an ISA adapter that has
3^ been previously configured to function in an EISA computer.
To reconfigure the adapter, install the adapter in either an ISA
or an EISA computer and follow steps 1 through 5 in the
section "Using the AutoLink Program" earlier in this chapter.
Then follow these steps:
1 When the main menu screen shown in Figure 3-2 appears,
select Configuration/Diagnostic/Troubleshooting and
press [Enter].
2 When the Configuration and Diagnostic screen appears,
select Configuration and Diagnostic Program.
Reconfiguring the Adapter for an ISA Computer
ITCM5095.CFG for the 3C509B-TPO adapter
3-9