Leica SPIDER GR30 User Manual page 41

GR30/GM30 User Interface
Buttons How to
3 s
•
OR
If any logging session had been active, the Raw data log-
ging LED is flashing red.
•
After logging has been started or stopped, the LED and
instrument functionality goes back to general behaviour.
Start/Stop all data streams
Activate the dual button functionality.
1 X
Press the Function button once until the
streams LED starts flashing slowly.
If all data streams had been off, the RT out data stream
LED is flashing green.
3 s
•
If any data stream had been active, the RT out data
stream LED is flashing red.
OR
•
After data streams have been started or stopped, the
LED and instrument functionality goes back to general
behaviour.
Initialise the measurement engine
Activate the dual button functionality.
2 X
Press the Function button twice until the
starts flashing slowly.
3 s
•
After the measurement engine has been initialised, the
LED and instrument functionality goes back to general
behaviour.
Format receiver settings
Activate the dual button functionality.
3 X
Press the Function button three times until the
LED starts flashing slowly:
Press and hold the Function button until the LED
flashes quickly to START all configured logging ses-
sions if the Raw data logging LED is flashing green.
Press and hold the Function button until the LED
flashes quickly to STOP all active logging sessions if
the Raw data logging LED is flashing red.
Press and hold the Function button until the LED
flashes quickly to START all configured data streams
if the RT out data steam LED is flashing green.
Press and hold the Function button until the LED
flashes quickly to STOP all active data streams if the
RT out data stream LED is flashing red.
Press and hold the Function button until the LED
flashes quickly to reset the measurement engine.
This action will delete all almanac and ephemeris
information and the instrument will take a few
minutes to restart tracking satellites.
RT out data
Position LED
Power
41