Install Usb Drivers; General; Setup Via Web Interface Over Usb - Leica SPIDER GR30 User Manual

6.4
6.4.1
Before you begin
6.4.2
Setup via web inter-
face over USB
Equipment Setup
Step Description
6. For a field campaign setup, select Logging/Streaming and start or
stop pre-configured data streams and logging sessions.
7. Press Enter to store all changes.
8. Refer to the "GR Series Operational Manual (Online Help) for further
details on using the instrument.

Install USB drivers

General

Before connecting the instrument to a computer using a USB cable, you must
first install USB drivers. To install the USB drivers refer to the GR/GM USB Driver
Installation Guide available on myWorld.
☞ Only one instrument can be connected to the computer via USB at a
time.

Setup via Web Interface over USB

6
GR10_023
Step Description
1. Turn on the instrument.
2. Start the computer.
3. Loosen the screw on the SD card/USB port cover.
4. Open the SD card/USB port cover.
5. Plug the USB cable into the USB port on the instrument.
6. Plug the USB cable into the USB port of the computer.
7. Open a browser and type in the IP address: 192.168.254.2 to access
the instruments web interface.
8. Use the default User name (Admin) and Password (12345678).
☞
After logging in the first time you must create a new user
account, including a new user name and password. The
default user account can then be deleted. Refer to the
"GR/GM Series Operational Manual (Online Help)" for a
step-by-step guide.
9. Configure the instrument for all required settings.
5
1
53