Operating The Control Panel; Opening The Settings - Siemens SIMATIC HMI Unified Comfort MTP700 Operating Instructions Manual

Operating the Control Panel

5.1

Opening the settings

The Control Panel can be opened as follows:
● After switching on the device, if there is no project on the HMI device.
● Via an appropriately configured operating element in your project.
● By terminating the project running on the HMI device.
The following figure shows the open main window of the Control Panel:
To make the corresponding settings, select an entry in the navigation area or a tile in the
window pane.
Note
Enabling password protection for the Control Panel
The password protection for the Control Panel is deactivated when the HMI device is
delivered, which means that all users can make changes in the Control Panel.
To protect your HMI device against unauthorized changes, you can activate password
protection for the Control Panel, see section "Control panel access (Page 99)".
Unified Comfort Panels
Operating Instructions, 03/2020, A5E46641217-AA
5
75